Filter
Top Products
6-6 A-61092 September 1999
Code Operator Message Displayed Description/Action Required
E281 OCR was reset — restart batch
Use the Next key to enter a starting image
address.
Rerun the batch.
E282 Comm buffer full — please wait System is busy. Wait until the message
clears, then continue.
E285 Feeder off due to OCR request System is busy. Feeder will be reactivated
when the system is no longer busy.
Wait until the message clears, then continue.
E286 Feed calibration target Calibration process has started.
Press Run and feed the calibration target into
the transport.
E291 Scanner disabled The machine has been disabled due to an
error. Determine the cause of the error via
the host system.
Enable the machine.
Press Run to continue.
E293 Host recovery required Contact your system administrator to initiate
the required action on the host system.
E294 Front calibration warning Perform maintenance/cleaning procedures
for the Document Scanning Array, imaging
guides, etc.
Check the lamps; replace if necessary.
Recalibrate the machine.
E295 Rear calibration warning Perform maintenance/cleaning procedures
for the Document Scanning Array, imaging
guides, etc.
Check the lamps; replace if necessary.
Recalibrate the machine.
E296 Target not seen Repeat the calibration process using a blank
target. If error repeats, call service.
E297 Document queue full The feeder and transport are stopped and
the machine is disabled.
Transfer images from the image buffer to the
host system.
Re-enable the machine.
Press Run to continue.
E298 Calibration required
Enter function code F37 to initiate the
calibration sequence.