Filter
Top Products
A-61092 September 1999 8-21
Using the Check Feeder / Check Stacker
The check feeder/check stacker provides continuous feeding of small-
sized documents; such as, checks.
Using the check
feeder
To use the check feeder, follow the procedures below:
NOTE: Thick documents may be processed with the check feeder
installed by using the hand-feed throat with the gap release lever
held down.
Check stacker
Front cover
Check guide
Left-side guide
Hand-feed throat
Side panel
switch
Feeder top cover
Gap adjustment knob
Gap release lever
1. Adjust the feeder left-side guide to accommodate the width of the
documents.
2. Turn on the side panel switch.
3. Adjust the feed and separator rollers for the thickness of the
documents.
4. Properly prepare the documents, removing any staples, rubber
bands, paper clips, or loose mending tape. Straighten any wrinkled
edges and torn documents.
5. Make sure the documents are evenly stacked, with the leading and
left edges square, for proper feeding and endorsement positioning (if
documents are to be endorsed).
6. Place the documents against the check guide.
7. Press Run to feed the documents.