Filter
Top Products
A-61092 September 1999 6-5
Code Operator Message Displayed Description/Action Required
E230 Open access door to correct error Open the access door.
Verify all operator accessible areas are
properly closed.
Press Run to continue.
E231 Press JOG, and try again
Press Jog and then press the Run key. Try
again.
E232 Close all access doors and RUN Close all access doors.
Press Run to continue.
E234 Press JOG, and try again
Press the Jog key and then press Run. Try
again.
E235
E236
Turn main power OFF and ON
• Turn the side panel switch off.
• Turn the main power switch off.
• Wait 5 to 10 seconds.
• Turn the main power switch on.
• Turn the side panel switch on.
If the error repeats, call service.
E238 User function string invalid The P-key, End-of-Batch, etc., definition
made during installation is invalid. Correct the
definition using the Mode Setup Software.
E240
E241
E242
E243
E244
E245
Enter correct level of IA — refeed Set or change the document image level or
use the Next key to enter a new image
address.
Press Run to continue.
E246 Conflicting input — what level? Set or change the document image level to
confirm the proper document image level.
Press Run to continue.
E267 Clear error, re-enter IA
Press Clear. Use the Next key to enter an
image address.
Press Run to continue.
E280 Feeder off due to host request System is busy. The feeder will be
reactivated when the system is no longer
busy.
Wait until the message clears and continue.