Filter
Top Products
5-6 A-61092 September 1999
Cleaning the separator roller:
1. Open the front cover.
2. Push the roller cover release lever toward the back of the machine.
3. Grasp and rotate the roller cover toward the back of the machine,
exposing the feeder module and separator roller.
4. Lift and remove the separator roller cover plate.
5. Lift the separator roller out of the grooved brackets.
6. Clean the separator roller. Inspect the roller any areas where the
white foam is showing through the roller cover. If the roller shows
signs of wear, obtain and replace the separator roller.
7. Replace the separator roller by aligning the pins in the grooved
brackets.
8. Reinsert the separator roller cover plate.
9. Close the feeder cover.
10. Close the front door.
Roller cover
Feeder module
Roller cover
release lever
Separator roller
Grooved brackets