Filter
Top Products
CONTENTS
INDEX
SEARCH
HELP
Operator’s Guide
Printing
Guide
Color Management
Calibration
Overview
Setting up the Printer
Operating the Printer
Troubleshooting
Site Specifications
Accessories
Customizing the
Printer
Network
Interface Guide
4.
To clean the print head, first use the water pad and then use the
alcohol pad. With each pad, wipe along the heater line four times:
–
Wipe the full length of the glass area (always in one direction).
–
Use a clean part of the pad for each wipe.
–
Apply firm, even pressure.
–
Wipe the metal roller bar and rod as shown.
5.
Allow the glass area to dry for about two minutes.
6. If reloading the ribbon
,
load the supply spool first (with the bar code
on the left. If the ribbon gets dirty or is damaged, wind the take-up
spool ahead to the next clean magenta section.
If loading a new ribbon,
refer to the instructions on the ribbon
package.
7.
Close the printer cover, and turn the printer
On.
AVOID METAL
EDGE!
4x
metal roller bar
rod