Filter
Top Products
CONTENTS INDEX SEARCH HELP
Operator’s Guide
Printing
Guide
Color Management
Calibration
Overview
Setting up the Printer
Operating the Printer
Troubleshooting
Site Specifications
Accessories
Customizing the
Printer
Network
Interface Guide
7. Remove the cover from the tray.
8. Remove the media and blue stiffener sheet from the tray.
9. Set the media on a freshly cleaned surface.
10. Insert the prepared pad holder into the paper tray.
NOTE: The posts on the bottom of the pad holder fit into the holes near
the front of the paper tray.
11. Load the paper tray back into the printer.
12. Press
Print
to make a test print.
13. Wait for the printer to cycle and for the error light on the display panel
to illuminate.
14. Remove the tray from the printer, and then reinsert it.
15. Wait for the printer to cycle and for the error light to illuminate again.
16. Remove the tray.
17. Remove the prepared pad holder from the tray.
18. Press
Cancel
to cancel the test print.
19. Load the media and stiffener sheet into the tray, and put the lid
back on.
20. Insert the tray in the printer.
IMPORTANT: Wait about five minutes for the rollers to dry before using the
printer.