Filter
Top Products
CONTENTS INDEX SEARCH HELP
Operator’s Guide
Printing
Guide
Color Management
Calibration
Overview
Setting up the Printer
Operating the Printer
Troubleshooting
Site Specifications
Accessories
Customizing the
Printer
Network
Interface Guide
Cleaning the Sensors
IMPORTANT: Before cleaning, turn the printer Off.
Follow these steps to clean the five ribbon sensors in the printer.
1. Locate the two sensors on top of and in the center of the print head.
They are visible behind the ribbon.
2. Remove the ribbon.
3. Wipe the sensors with an alcohol pad.
4. Replace the ribbon.
5. To locate the next two sensors, look above where a finished print
comes out for a steel plate with fringe. At the center of the plate,
about one inch back and down the slope, is an oval cutout with the
two receiver sensors.
6. Wipe the sensors with an alcohol pad.
7. To locate the fifth sensor, look at the lower ribbon spool. On the left
hand is a bar code label. Immediately above the bar code label is a
black box with wires coming out of it. The sensor is located on the
bottom of that box (the side of the box that faces the bar code label).
8. Clean the sensor area with an alcohol pad.