Konica Minolta 163 Network Card User Manual


 
7
Network settings
7-38 IC-206
2 Type in the port number.
A port number between 1 and 65535 can be specified. Normally,
port number 389 is used. If SSL is enabled, use port number 636.
3 Press the [OK] key.
After the message “ACCEPTED” appears, the “LDAP SETTING” menu
appears again.
Selecting the SSL setting
1 In the “LDAP SETTING” menu, press the [+] or [,] key until “SSL SET-
TING” is selected, and then press the [OK] key.
2 Press the [,] or [+] key until “DISABLE” or “ENABLE” is selected, and
then press the [OK] key.
Whether “DISABLE” or “ENABLE” is selected, the message “ACCEPT-
ED” appears, and then the “LDAP SETTING” menu appears again.