Konica Minolta 163 Network Card User Manual


 
Network printing
3
IC-206 3-5
3.2 Checking the setup
This section provides an overview of the setup procedure that is required for
each network printing method.
Peer-to-peer printing
1 Connect the network cable. (Refer to “Connecting to a local area net-
work (LAN)” on page 1-12.)
2 From the machine’s control panel, specify the IP address, subnet mask
and default gateway. (Refer to “Specifying an IP address” on page 3-9.)
3 Print the settings information, and then check the settings. (Refer to
“Printing the settings information” on page 3-13.)
4 Install the printer driver. The Peer-to-Peer Utility is installed when the
printer driver is installed.
For details on installing the PCL driver, refer to “Installing the printer
driver by using the Add Printer Wizard” on page 2-15.
If the GDI driver is to be installed, refer to the User’s Guide for the
GDI printer controller, included with this machine.
5 Add the network port to the computer. (Refer to “Connecting the com-
puter and this machine over a network” on page 3-15.)
2
Reminder
When installing the printer driver on an operating system other than Win-
dows 98 SE or Windows Me, the Peer-to-Peer Utility is not installed.