Filter
Top Products
4-72 Using the Operation Panel
Err. Clear Timer (Setting the error clear time)
If Auto Err. Clear is set to On and a non-fatal error (an error that
allows printing to continue) occurs, this setting specifies the time until the
error is recovered and printing resumes. The default setting is 30
seconds.
1 In the Timer Setting menu, press U or V to select Err. Clear
Timer.
2 Press [OK]. The Err. Clear Timer screen appears.
3 Use the arrow keys to set the recovery time.
Press U or V to increase or decrease, respectively, the value at the
blinking cursor.
Use Y and Z to move the cursor right and left.
4 Press [OK]. The recovery time setting is stored and the Timer Setting
menu reappears.
Sleep Timer (Sleep timer timeout time)
If Auto Sleep is set to On, you can adjust the length of time the printer
waits before entering Auto Sleep in the absence of data. The printer
reverts to normal operation mode when the printer receives a print job,
[OK] is pressed or one of the exterior covers is opened. The default time
is 45 minutes.
1 In the Timer Setting menu, press U or V to select Sleep Timer.
2 Press [OK]. The Sleep Timer screen appears.
3 Use the arrow keys to set the sleep time.
Press U or V to increase or decrease, respectively, the value at the
blinking cursor.
Use Y and Z to move the cursor right and left.
4 Press [OK]. The sleep time setting is stored and the Timer Setting
menu reappears.
Note Color calibration is automatically executed before the
printer reverts to normal operation mode.
Err. Clear Timer:
a
b
(5 - 495)
/**30-
sec.
M
Sleep Timer:
a
b
(1 - 240)
/45-
min.
M