Filter
Top Products
3.13 Other Modes
3-60
6
66
6
Press the U or V key to increase or decrease the
value at the blinking cursor and set the desired time.
The timer can be set between 5 and 240 min, in
5-minute increments. Use the Z and Y keys to move
the cursor right and left.
7
77
7
When the desired timeout time is displayed, press the
ENTER key.
8
88
8
To exit the menu selection, press the MENU key.
3.13.4 Received Data Dump
You can print data received by the printer as hexadecimal
code for debugging programs and files.
1
11
1
Press the MENU key.
2
22
2
Press the U or V key repeatedly until Others >
appears.
3
33
3
Press the Z key.
4
44
4
Press the U or V key repeatedly until > Print
HEX-DUMP appears.
5
55
5
Press the ENTER key. A question mark (?) appears.
6
66
6
Press the ENTER key again. The message
Processing appears for a second, followed by
Waiting.
7
77
7
While the message display is indicating Waiting,
send data to be hex-dumped to the printer. The
message display indicates Processing while the
data is being received.
You can cancel printing of any more dump data by
pressing the GO key and then the CANCEL key.
8
88
8
Once all data has been received, the message
Waiting will appear. Press the GO key to finish
hex-dump printing.
3.13.5 Printer Resetting
The procedure described below resets the printer’s temporary
conditions, such as the current page orientation, font, etc., set
by commands to their default values. Downloaded fonts and
macros are deleted from the printer’s memory.
1
11
1
Press the MENU key.
2
22
2
Press the U or V key repeatedly until Others >
appears.
3
33
3
Press the Z key.
4
44
4
Press the U or V key repeatedly until >Printer
Reset appears.
5
55
5
To reset the printer, press the ENTER key. A question
mark (?) appears.
Others >
>Print HEX-DUMP
>Print HEX-DUMP?
Processing
Waiting
Others >
>Printer Reset
>Printer Reset ?