Lenovo 429133U Tablet User Manual


 
If you forget your hard disk password, Lenovo cannot reset your password or recover data from the hard
disk. You must take your computer to a Lenovo authorized servicer or a marketing representative to have the
hard disk drive replaced. Proof of purchase is required, and a fee will be charged for parts and service.
Setting the ngerprint reader
If you want to change the settings of the ngerprint reader, follow the procedure below.
The ngerprint submenu under the Security menu of the ThinkPad Setup offers the following choices:
Predesktop Authentication: Enables or disables ngerprint authentication before the operating system
is loaded.
Reader Priority: Denes the priority for ngerprint readers if an external ngerprint reader is attached.
Security Mode: Species the settings of the security mode.
Password Authentication: Enables or disables password authentication.
Note: This item appears if High security mode is selected.
Reset Fingerprint Data: By choosing this item, you erase all of the ngerprint data stored in either the
internal or external ngerprint reader.
To set an item in the ngerprint submenu:
1. Print these instructions. To congure the ngerprint reader, you must turn your computer off and
then on again.
2. Save all open les, and exit all applications.
3. Turn your computer off and then on again.
4. When the logo screen is displayed, press F1. The ThinkPad Setup opens.
5. Using the cursor keys, move to Security, and press Enter. The Security menu opens.
6. Using the cursor keys, move to Fingerprint, and press Enter. The Fingerprint submenu opens.
7. Using the cursor keys, move to an item you want to set. When that item is highlighted, press Enter.
8. Set the items you want to set.
9. Press F10 to exit.
10. In the Setup Conrmation window, select Yes.
Care for the ngerprint reader
The following actions could damage the ngerprint reader or cause it not to work properly:
Scratching the surface of the reader with a hard, pointed object.
Scraping the surface of the reader with your ngernail or anything hard.
Using or touching the reader with a dirty nger.
If you notice any of the following conditions, gently clean the surface of the reader with a dry, soft, lint-free
cloth:
The surface of the reader is dirty or stained.
The surface of the reader is wet.
The reader often fails to enroll or authenticate your ngerprint.
If your nger has any of the following conditions, you may not be able to register or authenticate it:
Your nger is wrinkled.
Your nger is rough, dry, or injured.
104 User Guide