Filter
Top Products
Troubleshooting
• “Setup troubleshooting” on page 93
• “Print troubleshooting” on page 96
• “Copy troubleshooting” on page 98
• “Scan troubleshooting” on page 100
• “Fax troubleshooting” on page 102
• “Network troubleshooting” on page 106
• “Jams and misfeeds troubleshooting” on page 107
• “Memory card troubleshooting” on page 109
• “Error messages” on page 110
• “Removing and reinstalling the software” on page 117
Setup troubleshooting
• “Incorrect language appears on the display” on page 93
• “Power button is not lit” on page 94
• “Software does not install” on page 94
• “Page does not print” on page 95
• “Cannot print from digital camera using PictBridge” on page 96
Incorrect language appears on the display
Correcting a language
selection during initial
setup
After you select a language, Language appears again on the display. To change the
selection:
1 Press or repeatedly until the language you want appears on the display.
2 Press to save.
Selecting a different
language after initial setup
1 From the control panel, press Copy Mode.
2 Press
.
3 Press or repeatedly until Tools appears.
4 Press .
5 Press or repeatedly until Device Setup appears.
6 Press .
7 Press or repeatedly until Language appears.
8 Press .
9 Press or repeatedly until the language you want appears on the display.
10 Press to save.
Note: If you cannot understand the language on the display, see “Resetting to factory default
settings” on page 117.
93