Filter
Top Products
Step 1
Select a Recall memory to be the current setup memory. For example, to
make Recall memory 90 the current setup memory, press . (Recall
memory numbers may be any number from 01 to 99). If the selected Recall
memory did not previously exist, it will be created automatically.
Step 2
Press to access the Internal
Frequency Selection menu. Items one
to six contain preset scan frequencies
covering the scan range of the projector.
It is recommended that Recall memories
be created for each. To make a selection,
enter an item number or use and to
move the cursor bar to the item you want,
then press .
Tip: It is recommended that Recall memories for the two extreme frequencies
be set up first (items 1 and 4). When other Recall memories are created, their
initial display settings will be based on the settings already stored in memory.
Step 3
At this point, a test pattern is displayed. Make display adjustments as
required. All display settings will be stored in the Recall memory. To create
another Recall memory, repeat the above steps. To return to the external
source, press while only the test pattern is displayed.
(You may notice that as new Recall memories are created, fewer display
adjustments are required. This is because ASI is using other setup memories
to create the initial settings of the new memories.)
ASR Setup ➤ This subsection provides two examples of how the ASR feature may by used
and set up.
ASR Example #1
Refer to the system illustrated in Figure 2-23. A computer is connected to
slot 1 of the projector as shown. The graphics adapter in the computer can
operate at different frequency modes to accommodate various software
applications. The ASR feature may be used until when the frequency mode
of the computer changes, the projector setup also changes to match that of
the new mode.
EXIT
ENTER
6
1
UTIL
0
9
RECALL
INSTALLATION & SETUP
2.32