Filter
Top Products
Example 2
A single signal switcher is connected to the projector and a computer
is connected to slot 3 of the switcher. To display the computer output,
press .
Note: If a switcher is connected to the projector, its inputs can be selected using
the switcher’s front panel push buttons.
Direct Channel ➤
Selection
This method of source selection takes advantage of the Channel List feature
explained in section 3.7, Utility Features. The Channel List allows you to
assign a source to a 2-digit number, from 01 to 99.
Once you have assigned channel numbers to your sources, and the projector
is at operation level, you can select a source by pressing the 2-digit channel
number associated with it.
To select a channel, press .
where:
m = the 1
st
digit of the channel number
n = the 2
nd
digit of the channel number
n
m
SOURCE
INPUT
Switcher Number 1
The computer output
is connected to slot 3
of switcher number 1.
The switcher output
is connected to
slot 1 of the projector.
ON/OFF
STANDBY
PROJECTOR
ELECTROHOME
MARQUEE SIGNAL SWITCHER
123456789
3
1
SOURCE
The workstation output
is connected to
slot 1 of the projector.
SOURCE
INPUT
OPERATION
3.12