Filter
Top Products
The projector switches to, and displays, the source assigned to the channel
number. If an invalid switcher or slot number is assigned to the channel, a
warning message is displayed.
Example
Channel 08 in the Channel List was programmed to select a source connected
to slot 5 on switcher 3. To select this source, simply press .
Note: If the Channel Select option in the Preferences menu ( ) is set
to either “1 digit only “ or “1 or 2 Digits”, the preceding zero shown in the
example above does not have to be entered. For more information, refer to the
Preferences entry in Section 3.7.
Up/Down Channel ➤
Selection
This method of source selection also takes advantage of the Channel List
feature. It lets you quickly switch between channels programmed in the
Channel List by using the up and down arrow keys on the keypad.
To make a selection:
Press followed by or .
Each time an arrow key is pressed, a channel number (and name) is displayed
on the screen. When the channel number you want is displayed, simply wait
to allow the projector to switch to the source defined by the channel.
Notes: 1) If a channel specifies a switcher which does not exist, the channel is
considered invalid. 2) The Channel List utility allows you to flag the channels
to be used by the Up/Down Channel selection feature. For more information,
refer to the Channel List entry in section 3.7, Utility Features.
The Source ➤
Message
When
or
is pressed
at operation level, and/or a
source switch is made, a source
message is briefly overlayed on
the projection screen. The
source message displays current
source information.
Notes: 1) If screen messages are turned off via the Preferences menu ( ),
the source message is not displayed. 2) During input selection or Recall memory
selection (explained later), the message box displays numeric keypad entries as
they occur. In both cases, two digits must be entered. If only one digit is entered,
the message box will remain displayed until a second digit is entered or the
selection is cancelled by pressing . 3) When an internal source is in use, an
internal source message is displayed.
EXIT
2
5
UTIL
Channel
IBM PC
Input
Recall
ASI
01
01
13
S02-R06
Channel Number
Source Name
Input Number
Recall Memory No.
ASI Message
RECALL
SOURCE
SOURCE
45
UTIL
8
0
OPERATION
3.13