Filter
Top Products
Step 2
Press twice to display the Current Input Parameters status page. Check
to see if ASR is off for the current input. If it is on, press then press
to turn ASR off for the input.
Step 3
At the switcher, switch in one of the source devices. Select an unused Recall
memory as the current setup memory. For example, to make Recall memory
01 the current setup memory, press . Make display adjustments as
required. The display settings for the selected device will be stored in the
Recall memory. Repeat this step for the remaining devices.
Step 4
Press to display the Clear Setup dialog box. Move the cursor to
“Do It” then press to clear the display settings and frequency settings
of the input. By doing this, Input memory 01 will not be used during an
ASR search.
Step 5
Press to lock Input memory 01 to prevent display or frequency
changes to the Input memory.
Step 6
Press to turn ASR on for the input. The projector’s display settings
will automatically adjust to match the source selected by the switcher.
2.11 ACON Setup
This section provides setup and usage guidelines for systems which include
the ACON automatic convergence feature.
There are a few simple rules and operation fundamentals which should be
understood and considered when installing a projector which includes the
ACON automatic convergence feature. ACON operates on the principle of
monitoring projected screen images via its Locator Assembly, analyzing this
data, then adjusting the vertical and horizontal positions of the red and blue
colors until optimum convergence with the green is achieved. This process
requires that the view of the display screen by the Locator Assembly be
totally unobstructed. ACON’s performance can be adversely affected if the
projector’s optical and system functions are not properly set. Ensure the pro-
jector is focused and all user adjustments have been made prior to operating
ACON.
Figure 2-29 illustrates two common projection system configurations. ACON
responds differently for each configuration. The projector configuration is
determined by ACON during the Learn Screen process. Always perform a
Learn Screen for a new or changed installation. For more information on
Learn Screen, refer to section 3.6, Convergence Registration.
CON
4
1
UTIL
3
1
UTIL
ENTER
5
1
UTIL
1
0
RECALL
4
1
UTIL
EXIT
INSTALLATION & SETUP
2.35