Madrigal Imaging MP-9 Projector User Manual


 
In rare instances, flashing lights can trigger an epileptic seizure. During
ACON usage persons with epilepsy should look away from the screen.
4.2 Cleaning Clean the projector when required. Before cleaning, always unplug the
projector from the power outlet.
Lens Cleaning To avoid the risk of scratching the lenses, only clean the lenses if absolutely
required. A small amount of dust on the lenses will have very little effect on
picture quality. If the lenses must be cleaned, use a DRY soft cotton cloth.
Rub gently in a circular motion.
Case Cleaning Clean the case with a soft dampened cloth. Use a mild commercial cleaner.
Do not use liquid or aerosol cleaners.
ACON Cleaning
The lens on the ACON Locator Assembly is very tolerant to dust and
should only be cleaned if ACON performance is affected. Cleaning of the
lens (if required) must be performed with great care. Use a DRY soft cotton
cloth. Rub gently in a circular motion.
4.3 Trouble-
shooting
If the projector is not operating properly, note the symptoms of the problem
and use the following guide to assist you. If you cannot resolve the problem
yourself, contact your dealer for assistance.
Projector Response
Problems
Refer to the following if the projector is not responding to keypad commands.
Symptom: The projector will not turn on when
is pressed. All back panel
lights are off. See Figure 4-1.
Cause/Remedy: 1) The power cord may be dis-
connected. Check the power
cord connection at the wall
outlet and the projector.
Figure 4-1. Rear Panel LEDs
Symptom: The projector will not turn on when is pressed. Only the amber
LED on the back panel is lit.
Cause/Remedy: 1) may not have been held down long enough to initiate projector
power-up. Hold down for at least one second to initiate power-up.
2) If using an IR keypad, ensure it is pointed at the screen or the front of
the projector. If the keypad is configured for built-in or wired usage,
make sure it is properly connected to the projector.
POWER
POWER
POWER
POWER
CON
CON
MAINTENANCE
4.3