Filter
Top Products
104 Appendix A: BIOS reference
If an error message is displayed, you will have the option of either continuing with
the boot process, or entering Setup to re-configure the BIOS settings. When
prompted, press F1 to continue with the boot process, or press F2 to enter Setup.
BIOS Message Explanation
0200 Failure fixed Disk This message indicates that the fixed disk (or hard disk) is not working or is not configured properly.
Check to see if the hard disk is attached properly. Run Setup and find out if the hard disk type is
correctly identified.
0210 Stuck key This message indicates that a key on the keyboard is stuck.
0211 Keyboard error This message indicates that the keyboard is not working. Verify that the keyboard is plugged in
properly.
Keyboard Controller error * This message indicates that the keyboard controller failed the BIOS test. You might have to replace the
keyboard controller.
0220 Monitor type does not match
CMOS - Run Setup
This message indicates that the monitor detected by the BIOS is not correctly identified in Setup. You
must change the monitor settings in the Setup utility.
0230 System RAM failed at offset:
nnnn*
This message indicates that system RAM failed at offset nnnn of the 64K block of memory.
0231 Shadow RAM failed at offset:
nnnn*
This message indicates that shadow RAM failed at offset nnnn of the 64K block of memory.
0232 Extended RAM failed at address
line: nnnn*
This message indicates that extended memory is not working or is not configured properly at offset
nnnn.
0250 System battery is dead - replace
and run Setup
This message indicates that the CMOS clock battery is dead.
Replace the battery and run Setup to reconfigure the unit.
0251 System CMOS checksum bad -
Previous boot or Default Configuration
used
This message appears in one of the following cases:
• When booting your unit after the BIOS has been updated.
In this case, this message indicates that the BIOS has loaded the default setup configuration
settings into CMOS, because when the BIOS was updated, all CMOS memory data was cleared. If
the default values are not suitable for your application, enter Setup to change the settings.
• When the CMOS has been corrupted or modified incorrectly, perhaps by an application program
that changes data stored in CMOS.
In this case, this message indicates that the BIOS has tried to restore the Setup configuration
settings used during the previous BIOS boot. If these settings were corrupted, the BIOS has
loaded the default Setup configuration values.
If the error persists, check the unit’s battery (see Chapter 1: Before you begin for its location) or
contact Matrox.
0260 System timer error This message indicates that the timer test failed. This requires repair of the motherboard.
* If your unit displays one of these messages, write down the message and contact Matrox.
1
If your unit displays one of these messages, run the configuration utility.
MATROX IMAGING est distribué par TECHWAY - www.techway.fr - info@techway.fr - +33 (0)1 64 86 58 30