Filter
Top Products
48 Chapter 3: Adding devices to the Matrox 4Sight-M motherboard
Installing memory
To ins tal l m emo ry:
1. Ensure that the clips at each end of the module are spread.
2. Position the module over the DIMM slot, such that the notches along the module’s
bottom edge align with the notch in the DIMM slot.
3. Gently insert the bottom edge of the module into the slot.
4. Carefully close the clips over the side notch.
Adjusting your new memory settings
If the Matrox Imaging Library (MIL) or one of its derivatives is installed in your
unit, you must adjust your unit’s new memory settings using MilConfig (the MIL
Configuration utility). Refer to the software manual for more information on
using this utility.
DDR SDRAM module
clip
DIMM slot
notches
MATROX IMAGING est distribué par TECHWAY - www.techway.fr - info@techway.fr - +33 (0)1 64 86 58 30