Filter
Top Products
CDM-570/570L Satellite Modem with Optional IP Module Revision 4
Serial Remote Control MN/CDM570L.IOM
13–16
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Unit Test
Mode
TST= 1 byte, value
of 0 thru 6
Command or Query.
CDM-570L Test Mode, where:
0= Normal Mode (no test)
1=IF Loopback
2=Digital Loopback
3=I/O Loopback
4=RF Loopback
5=Tx CW
6=Tx Alternating 1,0 Pattern
Example: TST=1 (IF Loopback)
TST=
TST?
TST*
TST#
TST? TST=x
(see description of
arguments)
Unit Alarm
Mask
MSK= 12 bytes Command or Query.
Alarm mask conditions, in form abcdefghijkl, where:
a=Tx FIFO (0 = unmasked, 1 = masked)
b=G.703 BPV (0 = unmasked, 1 = masked)
c=Tx-AIS (0 = unmasked, 1 = masked)
d=Rx AGC Alarm (0 = unmasked, 1 = masked)
e=Eb/No Alarm (0 = unmasked, 1 = masked)
f=Rx-AIS
g=Buffer slip
h=Ext Reference alarm
i=BUC alarm
j=LNB alarm k=spare, l= spare
MSK=
MSK?
MSK*
MSK#
MSK? MSK=abcdefghijkl
(see description of
arguments)
Request to
Send
RTS= 1 byte, value
of 0 thru 3
Command or Query.
Defines how RTS/CTS will operate at the main data interface
0 = RTS/CTS Loop, No Action
RTS and CTS are looped, so that CTS echoes the state of RTS, but
RTS does not control the ON/OFF state of the carrier
1 = Loop, RTS Controls Tx O/P
RTS and CTS are looped, so that CTS echoes the state of RTS, and
RTS controls the ON/OFF state of the carrier (in other words, the
modem will not bring up its TX carrier until RTS is asserted.)
2 = Ignore RTS, Assert CTS
3 = 1:N system in use. RTS/CTS ignored (Query only) RTS is
ignored, and CTS is asserted unconditionally.
Example: RTS=0 (RTS/CTS Loop, No Action).
RTS=
RTS?
RTS*
RTS#
RTS? RTS=x
(see description of
arguments)