Filter
Top Products
CDM-570/570L Satellite Modem with Optional IP Module Revision 4
Serial Remote Control MN/CDM570L.IOM
13–31
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Command or Query. CDM-570L Only
ODU Global Configuration of CDM-570L in the form:
aabcdexxxxhhhhiiiijjjjjkxxxxxxlmnnnooopppppqxxxxxx, where:
OGC=
OGC?
OGC*
OGC#
OGC? OGC=aabcdfxxxhhhhiiii
jjjjjkxxxxxxlmnnnooopp
pppqxxxxxx
(see description of
arguments)
OGC Outdoor
Unit Global
Configuration
OGC= 50 Bytes
aa = BUC Address
b = BUC FSK comms enable
c = BUC Power Control
d = BUC 10MHz Frequency Reference enable
e = BUC Tx Output Enable
xxxx = expansion bytes
hhhh = BUC Low Alarm Limit
iiii = BUC High Alarm Limit
jjjjjk = BUC LO frequency, mix sign
xxxxxx = expansion bytes
l = LNB Power Control
m = LNB 10MHz Frequency Reference enable
nnn = LNB Low Alarm Limit
ooo = LNB High Alarm Limit
pppppq = LNB LO Frequency, mix sign
xxxxxx = expansion bytes
Any unavailable parameters will be filled with
xxx.
same as BAD
same as BCE
same as BPC
same as BFR
same as BOE
same as BCL
same as BCH
same as BLO
same as LPC
same as LFR
same as LCL
same as LCH
same as LLO
Where n=0 to 9
returns the OGC
portion of 1 of 10 stored
configurations
(see description of
arguments)
Note: The following codes are used in the ‘Response to Command’ column:
= Message ok
? Received ok, but invalid arguments found
* Message ok, but not permitted in current mode
# Message ok, but unit is not in Remote mode
~ Time out of an EDMAC pass-through message
+ Warning. Command accepted, but other parameters were changed in addition
OGC?n