Filter
Top Products
46 Motion Computing LE1600TC Tablet Client User Guide
Chapter
2
Using Your Motion Tablet Client
To set a BIOS system password:
1. Start the Tablet Client.
2. When the Motion Computing splash screen appears, quickly press
the Rotate Display button. If you miss the splash screen, turn the
Tablet Client off then back on and try this step again.
3. From the PhoenixBIOS Set Up Utility, tap Security on the menu bar.
4. To set up a System password, double-tap Enter next to Set
System Password.
5. Type in a System Password using the On Screen Keyboard.
6. Tap Enter.
7. Type in the password again to confirm it.
8. Tap Enter. The system returns to the Security screen and the Sys-
tem Password reads Set. A password is now required to enter the
PhoenixBIOS Set Up Utility.
9. To set up a Password on boot, tap Disabled next to
Password on boot until Enabled is highlighted. You will not be
prompted to type in another password because Password on boot
uses the System password.
NOTE: You cannot set up Password on boot until you set up
a System password.
10. If you have finished setting up a password, tap Exit or press the Esc
key on the Tablet Client to exit the PhoenixBIOS Set Up Utility.
11. When you exit, you are asked to select from the following options:
• Exit Saving Changes
• Exit Discarding Changes
• Load Set Up Defaults
• Discard Changes
• Save Changes
12. Select the desired action.
13. Confirm the selection by tapping Yes.
Disk Drive (DD) Password
To set up a password to start the Tablet Client (so no one can access the
information on the HDD of your Tablet Client even if it is removed and
installed in another Tablet Client without the proxy password):
To create a disk drive password:
1. Start the Tablet Client.
2. When the Motion Computing splash screen appears, quickly press
Rotate Display button. If you miss the splash screen, turn the Tablet
Client off then back on and try this step again.
3. From the PhoenixBIOS Set Up Utility, tap Security on the menu bar.
4. To set the HDD password, double-tap Enter next to Set Hard Disk
Password.