Filter
Top Products
Chapter 3: Software Installation
Multi-Tech Systems, Inc. 18
7. On the next screen you can select the COM port that the command PC will use when communicating with the
MultiVOIP unit. After software installation, the COM port can be re-set in the MultiVOIP Software (from the
sidebar menu, select Connection | Settings to access the COM Port Setup screen or use keyboard shortcut
Ctrl + G).
Note: If the COM port setting made here conflicts with the actual COM port resources available in the
command PC, the “Error in Opencomm handle” message will appear when the MultiVOIP program is
launched. If this occurs, you must reset the COM port.
8. A completion screen will appear.
Figure 3-4: Completion
Click Finish.
9. When setup of the MultiVOIP software is complete, you will be prompted to run the MultiVOIP software to
configure the VOIP.
Figure 3-5: Configuration
Software installation is now complete.