Filter
Top Products
Chapter 3: Software Installation
Multi-Tech Systems, Inc. 29
Actions:
• Select Outbound Phone Book
o Select Add Entry
o Accept Any Number may be selected to allow unmatched destinations an alternative
o Enter the number necessary to get out from the PBX system followed by the calling code of the
destination in the Destination Pattern field
o Enter the PBX access digit (same number as needed to get out of the PBX system) in the
Remove Prefix field
o Any digits that need to be added should be put in the Add Prefix field
o Enter the IP address of the call destination (add a Description if you like)
o Select a Protocol type (–SS models use SIP only, -FX models do not support H.323)
For H.323:
• Enter Gateway settings
For SIP:
• Select Transport Protocol, Proxy and URL if needed
For SPP:
• Enter Registrar settings if needed
o The Advanced Button will allow an Alternate IP Address to be entered for outbound traffic
• Select Inbound Phone Book
o Select Add Entry
o Accept Any Number for inbound traffic does not work when external routing devices are used
o Enter any access digits followed by the local calling code in the Remove Prefix field
o Enter any digits needed to access an outside line in the Add Prefix field
o Select Hunting in the Channel Number field to have the VOIP use the next available channel
o Add a description if you like
o Call Forward may be set up (details available in Chapter 5)
o Select Registration Option
• Repeat the Phone Book steps for any additional entries needed
Save & Reboot
Any time that you change settings on the VOIP unit, you must choose the Save & Reboot option; otherwise all
changes made will be lost when the MultiVOIP is reset or shutdown.