Filter
Top Products
T
ROUBLESHOOTING
6.7
6
Load Document
You have attempted to set up a
copy or fax operation with no
document loaded.
Load a document and try again.
[Low Heat
Error]
There is a problem in the fuser
unit.
Unplug the power cord and plug it back
in. If the problem persists, please
contact a service representative.
Open Heat Error
[Over Heat]
[LSU Error]
A problem has occurred in the
LSU (Laser Scanning Unit).
Unplug the power cord and plug it
back in. If the problem persists,
please call for service.
Memory Full
The memory is full. Delete unnecessary documents,
retransmit after more memory
becomes available or split the
transmission into more than one
operation.
[No Answer]
The remote fax machine has
not answered after several
redial attempts.
Try again. Make sure that the remote
machine is operational.
NO. Not
Assigned
The One-touch or speed dial
location you tried to use has
no number assigned to it.
Dial the number manually using the
number keypad or assign the number.
For storing a number, see page 2.16.
[No Paper]
Add Paper
The paper tray has run out of
paper.
Load paper in the paper tray. See
page 1.9.
Operation Not
Assigned
You are doing in the Add/
Cancel operation, but there is
no jobs waiting.
Check the display to see if there is any
scheduled job. The display should
indicate them in Standby mode, for
example, Delay Fax.
[Paper Jam 0]
Open/Close Door
Paper has jammed in the
feeding area of the paper tray.
Clear the jam. See page 6.3.
[Paper Jam 1]
Open/Close Door
•Paper has jammed in the
paper exit area.
•A paper jam has occurred in
the manual feeder or the
machine detects non-feeding
from the manual feeder.
• Clear the jam. See page 6.4.
• Clear the jam. See page 6.5.
[Paper Jam 2]
Check Inside
Paper has jammed in the fuser
area.
Clear the jam. See page 6.4.
Power Failure
Power has turned off then on
and the machine’s memory
has not been saved.
You need to start again the job which
you were trying to do before the
power failure.
Retry Redial?
The machine is waiting for a
specified time interval to redial
a previously busy station.
You can press Enter to immediately
redial, or Stop/Clear to cancel the
redial operation.
Display Meaning Suggested solutions