Filter
Top Products
www.netcomm.com.au Rev. 1- YML709
Page 60 NB1300Plus4 ADSL Modem
Advanced
LAN/DHCP
The LAN configuration page allows you to set the configuration for the LAN port.
LAN IP Address & Subnet Mask: The default is 192.168.1.1 and 255.255.255.0 you can
change it to another private IP address, such as 172.168.0.1, and 255.255.255.0. - For most
configurations it is recommended to leave it as default.
DHCP Server: System Allocated: The DHCP address pool is based on LAN port IP
address plus 12 IP addresses. For example, the LAN IP address is 192.168.1.1; the DHCP
address pool is at the range of 192.168.1.2 to 192.168.1.14.
User Defined: The DHCP address pool is at the range of User Defined Start Address and
User Defined End Address. The maximum pool size can be 253 IP addresses: 255 total IP
addresses - 1 broadcast address - 1 LAN port IP address.
DHCP Gateway Selection: The default setting for the DHCP Gateway Selection is
"Automatic". The user can select the "User Defined" to specify "User Defined Gateway
Address". The DHCP server will issue the "User Defined Gateway Address" to the LAN
DHCP clients.
Lease time: The Lease time is the amount of time of a network user will be allowed to
connect with DHCP server. If all fields are 0, the allocated IP addresses will be effective
forever.
User mode: Under the Single User mode, the DHCP server only allocates one IP address to
local PC. Under the Multiple User mode, the DHCP server allocates the IP addresses
specified bye the DHCP address pool.
Ethernet Mode Setting: The Ethernet Mode configuration page allows the user to set the
LAN port into Auto Sense, 100 Mbps Full Duplex, 100 Mbps Half Duplex, 10 Mbps Full
Duplex or 10 Mbps Half Duplex.