Filter
Top Products
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
10-2 Class of Service (CoS) Queuing
v1.0, May 2008
– IP Precedence
– IP DiffServ Code Point (DSCP)
The system can assign service level based upon the 802.1p priority field of the L2 header. You
configure this by mapping the 802.1p priorities to one of three traffic class queues. These queues
are:
• Queue 2 - Minimum of 50% of available bandwidth
• Queue 1 - Minimum of 33% of available bandwidth
• Queue 0 - Lowest priority, minimum of 17% of available bandwidth
For untagged traffic, you can specify default 802.1p priority on a per-port basis.
Untrusted Ports
• No incoming packet priority designation is trusted, therefore the port default priority value is
used.
• All ingress packets from Untrusted ports, where the packet is classified by an ACL or a
DiffServ policy, are directed to specific CoS queues on the appropriate egress port. That
specific CoS queue is determined by either the default priority of the port or a DiffServ or
ACL assign queue attribute.
• Used when trusted port mapping is unable to be honored - i.e. when a non-IP DSCP packet
arrives at a port configured to trust IP DSCP.
CoS Queue Configuration
CoS queue configuration involves port egress queue configuration and drop precedence
configuration (per queue). The design of these on a per queue, per drop precedence basis allows
the user to create the desired service characteristics for different types of traffic.
Port Egress Queue Configuration
• Scheduler Type
– Strict vs. Weighted
• Minimum guaranteed bandwidth
• Maximum allowed bandwidth
– Per queue shaping
• Queue management type