Filter
Top Products
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
IP Routing Services 7-3
v1.0, May 2008
CLI Examples
This diagram shows a Layer 3 switch configured for port routing. It connects three different
subnets, each connected to a different port. The script shows the commands you would use to
configure a 7000 Series Managed Switch to provide the port routing support shown in the diagram.
Example #1: Enabling routing for the Switch
Use the following command to enable routing for the switch. Execution of the command enables
IP forwarding by default.
Figure 7-1
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#exit