NETGEAR 7000 Series Switch User Manual


 
v1.0, May 2008
iii
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.
FCC Requirements for Operation in the United States
Radio Frequency Interference Warnings & Instructions
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following methods:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and the receiver
Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is connected
Consult the dealer or an experienced radio/TV technician for help.
Modifications made to the product, unless expressly approved by NETGEAR, Inc., could void the user's right to operate
the equipment.
Canadian Department of Communications Radio Interference Regulations
This digital apparatus (7000 Series Managed Switch) does not exceed the Class A limits for radio-noise emissions from
digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications.
FOR HOME OR OFFICE USE
Tested to Comply
with FCC Standards
7000 Series Managed Switch