Filter
Top Products
Switching Commands
114
ProSafe M4100 and M7100 Managed Switches
Note: This command is applicable only to physical interfaces.
no lacp partner system priority
Use this command to configure the default administrative value of priority associated with the
Partner
’s System ID.
Format no lacp partner system priority
Mode
port-channel local-preference
This command enables the local-preference mode on a port-channel (LAG) interface or
range of interfaces. By default, the local-preference mode for a port-channel is disabled. This
command can be used only on port-channel interfaces.
Default
Format port-channel local-preference
Mode
no port-channel local-preference
This command disables the local-preference mode on a port-channel.
Format no port-channel local-preference
Mode
port-channel static
This command enables the static mode on a port-channel (LAG) interface. By default the
static mode for a new port-channel is disabled, which means the port-channel is dynamic.
However if the maximum number of allowable dynamic port-channels are already present in
the system, the static mode for a new port-channel enabled, which means the port-channel is
static. You can only use this command on port-channel interfaces.
Default
Format port-channel static
Mode
Interface Config
disabled
Interface Config
Interface Config
disabled
Interface Config