Filter
Top Products
Management Commands
671
ProSafe M4100 and M7100 Managed Switches
no snmp-server community
Use this command to remove this community name from the table. The <name> is the
community name to be deleted.
Format no snmp-server community <name>
Mode
snmp-server community ipaddr
Use this command to set a client IP address for an SNMP community. The address is the
associated community SNMP packet sending address and is used along with the client IP
mask value to denote a range of IP addresses from which SNMP clients might use that
community to access the device. A value of 0.0.0.0 allows access from any IP address.
Otherwise, this value is ANDed with the mask to determine the range of allowed client IP
addresses. The name is the applicable community name.
Default
Format snmp-server community ipaddr <ipaddr> <name>
Mode
no snmp-server community ipaddr
Use this command to set a client IP address for an SNMP community to 0.0.0.0. The name is
the applicable community name.
Format no snmp-server community ipaddr <name>
Mode
snmp-server community ipmask
Use this command to set a client IP mask for an SNMP community. The address is the
associated community SNMP packet sending address and is used along with the client IP
address value to denote a range of IP addresses from which SNMP clients might use that
community to access the device. A value of 255.255.255.255 will allow access from only one
Default
• Public and private, which you can rename.
• Default values for the remaining four community names are blank.
Format snmp-server community <name>
Mode
Global Config
Global Config
0.0.0.0
Global Config
Global Config