NETGEAR M7100-24X Switch User Manual


 
Quality of Service (QoS) Commands
467
ProSafe M4100 and M7100 Managed Switches
service-policy
This command attaches a policy to an interface in the inbound direction. The
<policyname> parameter is the name of an existing DiffServ policy. This command causes
a service to create a reference to the policy.
Note: This command effectively enables DiffServ on an interface in the
inbound direction. There is no separate interface administrative
'mode' command for DiffServ.
Note: This command fails if any attributes within the policy definition
exceed the capabilities of the interface. Once a policy is successfully
attached to an interface, any attempt to change the policy definition,
that would result in a violation of the interface capabilities, causes
the policy change attempt to fail.
Note: Each interface can have one policy attached.
no service-policy
This command detaches a policy from an interface in the inbound direction. The
<policyname> parameter is the name of an existing DiffServ policy.
Note: This command causes a service to remove its reference to the
policy. This command effectively disables DiffServ on an interface in
the inbound direction. There is no separate interface administrative
'mode' command for DiffServ.
Format service-policy {in|out} <policymapname>
Modes
• Global Config
• Interface Config
Format no service-policy in <policymapname>
Modes
• Global Config
• Interface Config