NETGEAR M7100-24X Switch User Manual


 
IPv6 Commands
389
ProSafe M4100 and M7100 Managed Switches
no area virtual-link dead-interval(OSPFv3)
This command configures the default dead interval for the OSPF virtual interface on the
virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is
the Router ID of the neighbor
.
Format no area <areaid> virtual-link <neighbor> dead-interval
Mode
area virtual-link hello-interval (OSPFv3)
This command configures the hello interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the
Router ID of the neighbor. The range for <seconds> is 1–65,535.
Default
Format area <areaid> virtual-link <neighbor> hello-interval
<seconds>
Mode
no area virtual-link hello-interval(OSPFv3)
This command configures the default hello interval for the OSPF virtual interface on the
virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is
the Router ID of the neighbor
.
Format no area <areaid> virtual-link <neighbor> hello-interval
Mode
area virtual-link retransmit-interval (OSPFv3)
This command configures the retransmit interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the
Router ID of the neighbor. The range for <seconds> is 0–3,600.
Default
Format area <areaid> virtual-link <neighbor> retransmit-interval
<seconds>
Mode
Router OSPFv3 Config
10
Router OSPFv3 Config
Router OSPFv3 Config
5
Router OSPFv3 Config