Filter
Top Products
Switching Commands
82
ProSafe M4100 and M7100 Managed Switches
no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
Format no dot1x re-authentication
Mode
dot1x system-auth-control
Use this command to enable the dot1x authentication support on the switch. While disabled,
the dot1x configuration is retained and can be changed, but is not activated.
Default
Format dot1x system-auth-control
Mode
no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
Format no dot1x system-auth-control
Mode
dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state
machine on this port. Depending on the token used and the value (in seconds) passed,
various timeout configurable parameters are set. The following tokens are supported:
Interface Config
disabled
Global Config
Global Config
Tokens Definition
guest-vlan-period
The time, in seconds, for which the authenticator waits to see if any EAPOL packets are
received on a port before authorizing the port and placing the port in the guest vlan (if
configured).
The guest vlan timer is only relevant when guest vlan has been configured
on that specific port.
reauth-period
The value, in seconds, of the timer used by the authenticator state machine on this port
to determine when re-authentication of the supplicant takes place.
The reauth-period
must be a value in the range 1 - 65535.
quiet-period
The value, in seconds, of the timer used by the authenticator state machine on this port
to define periods of time in which it will not attempt to acquire a supplicant.
The
quiet-period must be a value in the range 0 - 65535.
tx-period
The value, in seconds, of the timer used by the authenticator state machine on this port
to determine when to send an EAPOL EAP Request/Identity frame to the supplicant.
The
quiet-period must be a value in the range 1 - 65535.