Filter
Top Products
Management Commands
678
ProSafe M4100 and M7100 Managed Switches
snmp trap link-status all
Use this command to enable link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled.
For more information, see
snmp-server enable traps linkmode on
page 674.
no snmp trap link-status all
Use this command to disable link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled.
For more information, see
snmp-server enable traps linkmode on
page 674.
show snmpcommunity
Use this command to display SNMP community information. Six communities are supported.
You can add, change, or delete communities. The switch does not need to be reset for
changes to take effect.
The SNMP agent of the switch complies with SNMP Versions 1, 2 or 3. For more information
about the SNMP specification, see the SNMP RFCs. The SNMP agent sends traps through
Format no snmp trap link-status
Mode
Interface Config
Format snmp trap link-status all
Mode
Global Config
Format no snmp trap link-status all
Mode
Global Config