Filter
Top Products
Page 468 of 544 NTAK10 2.0 Mb DTI card
553-3011-100 Standard 14.00 January 2002
• software-selectable digital pads on a per channel basis
• frame alignment and multiframe alignment detection
• frame and multiframe pattern generation
• CRC-4 transmission and reception (software selectable)
• card status and alarm indication with faceplate-mounted LEDs
• Periodic Pulse Metering (PPM) counting
• outpulsing of digits on any of the abcd bits
• Card-LAN for maintenance communications
• per-channel and all-channel loopback capabilities for near-end and far-
end
• self-test
• download of incoming abcd validation times from software
• warm SYSLOAD (TS16 AS16 transmitted)
Applicability to France
Features specific to DTI requirements for France are implemented in
firmware, and are switch-accessed. The requirements met are as follows:
• transmission and reception of alarm indication signaling (AIS) in TS16
(card disabled, warm SYSLOAD, etc.)
• France-specific PPM counting
• decadic dialing
• France-specific alarm report and error handling
Physical description
The 2Mb DTI pack uses a standard IPE-sized (9.5" by 12.5"), multilayer
printed circuit board. The faceplate is 7/8" wide and contain six LEDs.