Filter
Top Products
Installing the Passport 4400 Passport 4400 Hardware Installation Manual
2-3
Environmental Specifications
Temperature - Operating: 0 to 50
°
C (32
°
to 122
°
F)
Storage: -40
°
to 70
°
C (-40
°
to 158
°
F)
Relative Humidity - Operating: 10% to 90% (non-condensing)
Storage: 0% to 95% (non-condensing)
Unpacking Your Passport 4400 Unit
Follow the instructions below to unpack your Passport 4400 unit.
1. Read the labels on the box prior to opening the box.
Note:
Make sure that you keep the packing list included. It contains
model numbers and information about the Passport 4400 unit
and all modules included.
2. Remove the shipping material and any hardware (cables, modules, etc.)
shipped in the box along with the Passport 4400 unit. Place these
modules on a table near the installation site.
3. Slowly ease the Passport 4400 unit out of the carton by firmly gripping
its sides and lifting straight up. (Be sure to use proper lifting technique
when removing the Passport 4400 unit from the carton. Do not bend
over at the back when lifting.)
4. Place the equipment out on a table close to the installation site.
5. Check the packing list against the contents. Report any damage or lost
articles to the shipping carrier.
6. Save the packing materials in case you need to move the unit.
Once the carton is unpacked, verify that you have received all the equipment
you have ordered.
Passport 4400 Rackmount Kit
The Passport 4400 unit may be installed in a rack using an available Passport
4400 rackmount kit.
In addition to the rackmount shelf, each kit contains the following parts:
• Four screws
• Four washers — nylon filler
• Four washers — nickel finish
• Four clip nuts