Packard Bell NS1 1HR Laptop User Manual


 
www.packardbell.com
45
Adding or replacing memory modules
Tools you need to complete this task:
Screws removed during this task:
3 black M2.5×6 (bay cover)
To add or replace memory modules:
1 Complete the steps in “Preparing the notebook” on page 37.
2 Complete the steps in “Removing the bay cover” on page 39.
3 If you are replacing a memory module, go to step 4.
If you installing an additional memory module, go to step 5.
4 Use a non-marring plastic scribe to push out the latches on both sides of
the memory slot until the module tilts upward (1), and then remove the
memory module from its slot (2).
5 Insert the new memory module at a 30° angle into an empty memory slot,
and then press it down until it clicks into place.
The module is keyed so it can only be inserted in one direction. If the module
does not fit, make sure that the notch in the module lines up with the tab in
the memory slot.
6 Reinstall the bay cover.
Important
Use only memory modules designed for this notebook.
Phillips #0 screwdriver
Non-marring plastic scribe