Filter
Top Products
CHAPTER 3: Replacing notebook components
48
Replacing the palm rest module
Tools you need to complete this task:
Screws removed during this task:
• 3 black M2.5×6 (bay cover)
• 1 black M2×3 (hard drive)
• 1 black M2.5×6 (optical drive)
• 9 black M2.5×6 (palm rest - base side)
To replace the palm rest:
1 Complete the steps in “Preparing the notebook” on page 37.
2 Complete the steps in “Removing the battery” on page 38.
3 Complete the steps in “Removing the bay cover” on page 39.
4 Remove the hard drive screw, and then remove the hard drive from its
compartment.
5 If the notebook has a wireless card installed, unplug the antenna cables.
Phillips #0 screwdriver
Flat screwdriver or Non-marring plastic scribe