Filter
Top Products
2. Installation
17
2 InstallationBase Unit
2.1 Ink film installation /
replacement
Important:
L Remove all blue shipping tape from the
unit before installation.
2.1.1 Installing the ink film
The included film roll is a starter ink film.
1 Open the front cover by pulling up the centre
part.
2 Release the back cover by pushing the green
button (1).
3 Open the back cover.
4 Insert the front ink film roll by inserting its
blue gear into the left slot of the unit (1).
Insert the rear ink film roll by inserting its
white gear into the left slot of the unit (2).
L The ink film is safe to touch and will not
rub off on your hands like carbon paper.
L Make sure the blue gear (1) and white
gear (2) are installed as shown.
5 Turn the blue gear (1) in the direction of the
arrow until the ink film is tight (2).
1
1
2
1
2
FC243AL-PFQX2096ZA-en.book Page 17 Thursday, September 30, 2004 3:37 PM