Filter
Top Products
2000-A2-GB20-10 - 84 - February 2004
To delete the PVC, type Y, or cancel the deletion by typing any other
character.
3. The IAD saves the configuration and displays the PVC Configuration
menu where you may continue with other PVC management tasks.
4. Reset the IAD (page 14) when you finish PVC configuration.
Showing Current PVCs
To display a list of current PVCs, type 4.
The IAD displays the port list with associated PVCs:
Port VPI VCI Encapsulation Type PCR Service
1 0 40 RFC 1483 (with LLC Encapsulation) 3641 UBR
2 100 39 RFC 1483 (with LLC Encapsulation 4 CBR
--------
Total = 3645 cps
Maximum PCR this interface can support = 4830 cps
When you’re done viewing the list, press any key to return to the ATM PVC
Configuration menu.
Configuring
ATM
Options
To configure ATM options, type 4 to display the ATM Configuration menu:
Figure 4–54. ATM Configuration Menu
To perform these tasks, type the option and proceed to the corresponding
section. The tasks in this section are described beginning at the ATM
Configuration menu.
Configuring Payload Scrambling (following)
Configuring F4 OAM VPI (page 85)
Configuring F4 OAM Type (page 85)
Displaying F4 OAM Configuration (page 86)
Sending OAM Loopback (page 86)
Configuring EmptyCells (page 86)
Configuring Payload Scrambling
You must enable payload scrambling (which is disabled by default) for the
IAD to connect to a DSLAM that uses payload scrambling.
To enable or disable payload scrambling:
*****************************************
ATM Config Menu
*****************************************
1. Configure Payload Scrambling
2. Configure F4 OAM VPI
3. Configure F4 OAM Type
4. Display F4 OAM Configuration
5. Send OAM Loopback
6. Configure EmptyCells