Filter
Top Products
2000-A2-GB20-10 - 92 - February 2004
Enabling Automatic Fragment Sizing
1. Type 2 to enable automatic fragment sizing.
2. The IAD saves the configuration and displays the FR FRF.12
Configuration menu. Press Escape to continue.
3. Reset the IAD (page 14) when you finish Frame Relay configuration.
Setting the Fragment Size Manually
1. Type 3 to manually set fragment sizing.
The IAD displays the fragment size prompt:
Enter maximum fragment size in ms (0-50) or bytes
(100-1600) [0]:
Type the maximum fragment size and press Enter.
2. The IAD saves the configuration and displays the FR FRF.12
Configuration menu. Press Escape to continue.
3. Reset the IAD (page 14) when you finish Frame Relay configuration.
CopperMountain Fragmentation Configuration
If you selected Configure CopperMountain Fragmentation, the IAD
displays the CopperMountain FR FRF.12 Configuration menu:
Figure 4–63. FRF.12 Configuration Menu for CopperMountain
Type the option and proceed to the corresponding section.
Enabling or Disabling Coppermountain Fragmentation
1. Type 1 to enable or disable CopperMountain fragmentation.
The IAD displays the status and a prompt:
CuMtn Fragmentation is currently DISABLED
Enter E to Enable, D to Disable:
Type E to enable CopperMountain fragmentation. Type D to disable it.
2. The IAD saves the configuration and displays the FR FRF.12
Configuration menu. Press Escape to continue.
3. Reset the IAD (page 14) when you finish Frame Relay configuration.
Setting Real Time DLCI
1. Type 2 to set up the IAD for real time DLCI.
2. The IAD displays the port list and prompt:
Port DLCI Encapsulation
---- ----- -------------
1 16 RAW (No Encapsulation)
Select Port: [1-8]
NOTE
With CMCP enabled, the DSLAM controls fragmentation
settings, and IAD configuration is not required.
*****************************************
FR FRF.12 Configuration
*****************************************
1. Enable/Disable CuMtn Fragmentation
2. Set Real-Time DLCI