Filter
Top Products
2000-A2-GB20-10 - 156 - February 2004
The DHCP
Server
Configur-
ation Menu
The DHCP Server commands are all displayed on the DHCP Server
Configuration menu (displayed by typing D on the Main menu).
Tasks in this chapter are all described beginning at this menu:
Figure 9–1. DHCP Server Configuration Menu
You may sign on as Supervisor or Network Manager to configure the IAD
for use as a DHCP Server. Options that display in the DHCP Server
Configuration menu are the same for both security levels.
Using
DHCP
Debugging
Messages
The commands in option B, Enable/Disable DHCP Debug Messages, are
reserved for use by Paradyne network engineers.
Enabling
and Dis-
abling
DHCP
Server
When you enable DHCP Server, the IAD sequentially displays and
processes the required configuration commands beginning with Enable
DHCP Server.
To enable or disable DHCP Server, follow these steps:
1. Type E to select Enable/Disable DHCP.
2. If DHCP Relay is enabled, the IAD displays this prompt:
DHCP Server and DHCP Relay cannot both be enabled!
Do you wish to disable DHCP Relay? (N)
Type Y to disable DHCP Relay and enable DHCP Server, and proceed
to step 4.
*******************************************
DHCP Server Configuration Menu
*******************************************
E. Enable/Disable DHCP
H. Enable/Disable Checking Additional DHCP Servers
B. Enable/Disable DHCP Debug Messages
I. Configure DHCP Server Parameters
P. Configure DHCP Address Range Pool
C. Configure DHCP Client Entry
F. Display DHCP Configuration
S. Display DHCP Server Statistics
A. Display DHCP Server Assigned Addresses
U. Display DHCP Server Unassigned Addresses
D. Display DHCP Entry Details
X. Delete A DHCP Client Entry
Y. Delete A DHCP Assignment Entry
NOTE
Be sure to reset the IAD (page 14) when after configuring the
IAD as a DHCP Server. Resetting the IAD causes the
configuration changes to take effect.