Filter
Top Products
2000-A2-GB20-10 - 193 - February 2004
Figure 12–3. Clear Network Statistics Menu
To permanently reset statistics for a specific protocol, type the option.
The IAD immediately resets all statistics for the specified protocol, and
displays the menu.
Continue resetting network statistics, or press Escape to return to the
Network Statistics menu.
Interface
Statistics
Reports
Type I on the Reports menu to display interface statistics reports. The
Interface Statistics menu contains commands to display information about
the packets handled between layer 2 and layer 3 on a per port basis, and
to clear statistics for specific protocols.
To display specific interface statistics, first select an interface and
optionally a port. The IAD then displays the report, as shown in these
steps:
1. The IAD displays the interfaces on this IAD, and a prompt:
Available Interfaces:
1. T1/E1
2. 10/100BaseT Ethernet
0. (Abort)
Type the number of the interface.
2. If there is more than one port, the IAD displays the port list and prompt:
Port DLCI Encapsulation
1 18 Proprietary Voice DLCI
Select Port: [1-8]
Type the port number and press Enter.
3. The IAD displays the Interface Statistics menu:
Figure 12–4. Interface Statistics Menu (all options shown)
To display a specific report, type the option.
C. Clear ICMP Statistics
G. Clear IGMP Statistics
I. Clear IP Statistics
P. Clear PIM Statistics
T. Clear TCP Statistics
U. Clear UDP Statistics
NOTE
The commands that display on the Network Statistics menu
vary, based on the WAN module and configuration of the IAD.
A. Display ARP Statistics
I. Display Interface Statistics
B. Display Bridge Statistics
D. Display DLCI Statistics
Z. Clear a Statistic
Z. Clear ATM PVC Statistics
Option D displays “PVC
Statistics” when IAD is
configured for ATM.
(Ethernet only)