Filter
Top Products
2000-A2-GB20-10 - 141 - February 2004
Setting Admin State Globally
1. Type 1 to enable or disable the admin state for all ports.
2. The IAD displays this prompt:
Enter E to Enable, D to Disable:
Type E to enable the admin state, or D to disable it.
3. The IAD saves the mode you’ve selected and displays the menu.
4. Press Escape to return to the Port Administration menu and continue
with other voice path configuration.
5. Reset the IAD (page 14) when you finish voice path configuration.
Displaying the Current Admin State
Type 2 to display the current admin state by port number.
The IAD displays the following report:
1 DISABLED
2 ENABLED
3 DISABLED
4 DISABLED
Press any key to return to the Port Administration menu.
Configuring Admin State per port
1. Type 3 to enable or disable the admin state for a specific port. The IAD
displays the port prompt:
Select Line: [1-8]
Type the port number to set.
2. The IAD displays the following prompt:
Enter E to Enable, D to Disable:
Type E to enable the admin state, or D to disable it.
3. The IAD saves the mode you’ve selected and displays the menu.
4. Press Escape to return to the Port Administration menu and continue
with other voice path configuration.
5. Reset the IAD (page 14) when you finish voice path configuration.
Restarting an Endpoint
Type 4 to reset the connection between the Voice Port phone and the
MGCP voice gateway.
You use this option if one side of the link incorrectly identifies a call as up
and the other side thinks the call as down.
To reset the connection, type the number of the port and press Enter.
Configuring Default Packet Size
1. Type P to configure the packet size (default 5.5 ms).
2. The IAD displays the following prompt:
Enter packet size in ms [5.5]>
Type the packet size value and press Enter.
3. The IAD saves the new packet size and displays the menu.
4. Press Escape to return to the MGCP menu and continue with other
voice path configuration.
5. Reset the IAD (page 14) when you finish voice path configuration.