Filter
Top Products
Pelco Manual C1000M-B (1/96) 9
4.3 CHANNEL SETUP
There are two ways you can view your current channel
parameters:
1. Press the “1” key on your keypad while in the
monitoring mode.
2. Select CHANNEL SETUP (#1) in the MAIN PRO-
GRAM MENU.
After executing one of these steps, an example of what
you might see is shown below:
SELECTED: CHANNEL
Pelco PIM STANDARD
9600 BAUD,8 BITS,OFF PARITY
NRZ,ASCII,DATA INVERT
DEVICE ADDRESS 1 = 00H 0
DEVICE ADDRESS 2 = 00H 0
NOR. VID,OFF ID.,30 CHARACTERS
18 LINES,DATA DWELL=0
ALARM DWELL : 6/D1
EALRM = ON/VP PNTR = OFF
CHANNEL PROGRAM SELECTION MENU
1. COMMUNICATION SETUP
2. DATA FORMAT/COMMUNICATION PROTOCOL
3. VIDEO PARAMETERS
4.3.1 Communication Setup
This selection allows you to set COMMUNICATION
PARAMETERS and DEVICE ADDRESSES. The com-
munication parameters must be programmed correctly
in order for the Inter-Check ICI1000S Series to accept
data from your interface. Device addresses are used pre-
dominantly in ATM programming. Upon entering this
menu, you will notice that the channel’s current COM-
MUNICATION SETUP parameters are displayed as
shown below.
COMMUNICATION SETUP MENU
SELECTED: 9600 BAUD,8 BITS,OFF PARITY
NRZ,ASCII,DATA INVERTED
DEVICE ADDRESS 1 = 00H 0
DEVICE ADDRESS 2 = 00H 0
1. COMMUNICATION PARAMETERS
2. DEVICE ADDRESSES
NOTE: If the current settings are accept-
able, press the ESC key which returns to the
CHANNEL PROGRAM SELECTION
MENU. If you wish to change the communi-
cation parameters, press “1”. To change the
device addresses press “2”.
4.3.2 Communication Parameters
This menu enables you to program the data string for-
mat, baud rate, and character set into the Inter-Check
ICI1000S series.
NOTE: If you do not want to change items
within this menu, simply press ESC. The ESC
key will save the contents on the current line
and bring you to the prompt on the next line.
BAUD RATE =?
This prompt enables you to change the baud rate. Enter
the appropriate data and press ENT to save. Use 9600
when connecting to a PIM. Setting the baud to 0 will
turn off the data channel.
BITS (7 or 8) =?
Enter the appropriate number of data bits by pressing a
7 or 8 on your keypad. Use 8 when connecting to a
PIM.
PARITY = 1. ODD, 2. OFF, 3. EVEN
Enter the correct parity configuration of your device
by selecting 1, 2 or 3. Choose #2 for a PIM.
1=NRZ OR 2=NRZI
Choose the appropriate code transmission format by
selecting 1 or 2. NRZ is the most common format. An
exception to this is the SNA/SDLC type of communi-
cations. Select #1 for normal PIM applications.