Filter
Top Products
34
Chapter 2 Basic Fax Transmission
Verification Stamp
This function confirms successful transmission or storage
into the memory by stamping at the bottom of each
successfully transmitted original(s) with a small “x” mark.
zThe standard setting of the verification is Off. It stamp can be changed with “04 Stamp (HOME)” in Function
Parameters (Fax/Email Settings> Fax Parameters). For instructions on how to change the standard setting,
refer to Fax/Email Settings in the Operating Instructions (For Function Parameters) on the provided CD-ROM.
zThe machine can be configured not to stamp the documents stored in the memory by changing the setting
“28 Stamp at Memory XMT” in Function Parameters (Fax/Email Settings> Fax Parameters). For instructions
on how to configure the verification stamp, refer to Fax/Email Settings in the Operating Instructions (For
Function Parameters) on the provided CD-ROM.
zVarification Stamp function is only available when scanned with the ADF.
1
Place Original(s).
zRefer to
Placing Originals (Facsimile/Internet
Fax) in the Operating Instructions
(For Basic
Operations) of provided booklet.
2
Press the Fax key.
3
Select “Basic Menu”.
4
Select “Verification Stamp”.
5
Set “Quality Adj.” as required.
zRefer to Setting Original Quality (see page
26).
6
Select a destination.
zRefer to Entering a Destination (see page
16).
7
Press the Start key.
The original(s) are stored into memory with a
file number. Then starts dialing the telephone
number.
zSetting of "Verification Stamp" is returned
to Off after finished transmission.
Verification Stamp
Ex: Scanning
Direction