Filter
Top Products
36
Chapter 2 Basic Fax Transmission
Transmitting a Document Stored in Memory
Documents can be quickly scanned and stored in the memory before transmission.
This feature allows you to send the documents to multiple destinations without having to scan the
same documents over again. It also allows you to retrieve your original(s) immediately without having
to wait for the fax transmission to complete.
In addition to the memory transmission, the machine supports the direct transmission feature. In direct
transmission, a document is transmitted without storing it into the memory.
zIf the memory overflows while original(s) are being scanned for transmission to a single destination, the
machine will operate in the following manner:
If the quick memory transmission feature is set to “On” in Function Parameters
The document is transmitted up to the portion that was stored into the memory, and an error message
“Memory size over code = 870” is displayed.
If the quick memory transmission feature is set to “Off” in Function Parameters
The document is transmitted up to the portion that was stored in the memory, and then switches to direct
transmission and transmits the remaining original(s) in the ADF during the same phone call.
zIf the memory overflows while original(s) are being scanned for transmission to multiple destinations, a
message appears asking whether to transmit the successfully stored documents in memory or to cancel the
transmission. Select “Yes” to start transmitting, or “No” to cancel. If no action is taken within 10 seconds, the
machine will start transmitting the stored documents.
zThe transmission of a document terminates if memory overflows when the first page is transmitted.
zThe standard setting of Memory Transmission is "On" and it can be changed with “05 Memory (HOME)” in
Function Parameters (Fax/Email Settings> Fax Parameters). For instructions on how to change the standard
setting, refer to Fax/Email Settings in the Operating Instructions (For Function Parameters) on the provided
CD-ROM.
zThis "82 Quick Memory XMT" in Function Parameters (Fax/Email Settings> Fax Parameters) can be
configured to start transmitting a document when the first page is stored. This transmission mode is called
“quick memory transmission.” The standard setting of Quick Memory Transmission is "On". For instructions on
how to change the standard setting, refer to Fax/Email Settings in the Operating Instructions (For Function
Parameters) on the provided CD-ROM.
zYour machine is preset to transmit all documents from memory.
Original(s)
Original(s)
Stores all the
original(s) into
memory first, and
then starts its
transmission
Starts transmitting
when the first page
is stored in the
memory
Memory
Memory
destination
machine(s)
Quick Memory TransmissionMemory Transmission
destination
machine(s)