Filter
Top Products
152
Appendix NAVI/AV
Messages and How to React to Them
Messages for navigation functions
The following messages may be displayed by your navigation system.
❒ There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
The picture is stretched, the aspect is
incorrect.
The aspect setting is incorrect for the
display.
Select the appropriate setting for that
image.
➲ “Changing the wide screen
mode” ➞ Page 117
➲ “Setting the aspect ratio” ➞
Page 116
A parental lock message is displayed
and DVD playback is not possible.
Parental lock is on. Turn parental lock off or change the
level (➞ Page 117).
Parental lock for DVD playback can-
not be cancelled.
The code number is incorrect. Input the correct code number. (➞
Page 117).
Playback is not with the audio lan-
guage and subtitle language settings
selected in [DVD-V Setup].
The DVD playing does not feature
dialogue or subtitles in the language
selected in [DVD-V Setup].
Switching to a selected language is
not possible if the language selected
in [DVD-V Setup] is not recorded
on the disc.
Dialing is not possible because the
touch keys for dialing are inactive.
Your phone is out of range for serv-
ice.
Retry after entering within range for
service.
The connection between mobile
phone and the Bluetooth unit (sold
separately) (navigation system) can-
not be established now.
Perform the connection process.
The mobile phone is not registered to
the navigation system yet.
To use the mobile phone featuring
the Bluetooth wireless technology
with this navigation system, the reg-
istration process is necessary.
Symptom Cause Action (See)
Message When What to do
Irregular speed pulse signal
detected. Please power off the sys-
tem and check the installation. Then,
please re-boot the system and press
“OK”.
If the navigation system does not
receive the vehicle speed pulse.
Consult your Pioneer dealer.
Speed pulse not connected. Calibra-
tion will start without speed pulse.
Accuracy is not fully ensured without
speed pulse.
The speed signal input (pink lead
wire) of the power cable is not con-
nected.
To operate with 3D hybrid mode, con-
nect the speed signal input (pink
lead wire) of the power cable cor-
rectly.
Although it can be operated in Sim-
ple hybrid mode without connecting
the speed signal input, the precision
of the positioning will be less accu-
rate.
Vibration detected. Please power off
the system and check the installa-
tion. Then, please re-boot the system
and press “OK”.
The navigation unit is installed in a
place where it may be affected by a
large vibration.
Re-install the navigation unit in a
place where the unit will not be
affected by vibration.
Direction of G sensor is not correct.
Please power off the system and
check the installation. Then, please
re-boot the system and press “OK”.
Direction of G sensor is set incor-
rectly.
See the Installation Manual and set
the direction of the navigation unit
correctly.